Product Description
SETA is a special breathable plaster which reproduce a final alcantara fabric effect.
SETA is available in the following bases: SILVER and GOLD.
The ease of application combined with the delicate and refined alcantara effect make this plaster ideal to give a warm touch to both classic and modern environments.
Gallery
For the interior the product can be applied to any type of wall surface and/or other supports properly prepared.
The high breathability allows it to be used even in the presence of humidity. In addition, thanks to its features, it can also be used in highly frequented places such as public walls.
Technical Features
Yield：3-4m²/Lt for Trowel;6-7m²/Lt for Roller
Application
– The surface to be treated must be dry. Conditions and thickness of the plaster layer affect the drying and hardening time, so make sure it has at least 28 days of curing time, depending on temperature.
– The substrate has to be well prepared and suitable for coating: dry plaster, not any granules from plaster. In case of old walls make sure there is no poor or dusty paint: remove them if necessary as well as flaking paint.
– Apply 1 coat of PRIMER insulation if necessary.
– Apply with a brush or roller, one or two coats of FONDO which has to be thinned up to 5-10 % with water.
-Allow to dry perfectly, depending on the temperature (from 6 to 12 hours).
APPLICATIONE A SPATOLA:
– After checking the color chart, add to the base, the quantity of dye necessary to obtain the desired colour.
– Sand as necessary using medium or fine grain sandpaper in order to refine any imperfections.
– Proceed shaving the surface with the coloured plaster SETA, using a stainless steel trowel.
– Allow to dry totally and perfectly (from 6 to 12 hours), then refine any imperfections with glass paper.
– Apply the 2nd coat of SETA following the same procedure.
– Clean the trowel with a sponge smoothing the product just applied on the surface.
– Remove the joint material from the trowel with a clean sponge.
– Repeat this operation in order to recreate light and shadow effects, typical of the alcantara fabric.
– Allow to dry to appreciate the effect.
APPLICATIONE A RULLO:
– After checking the color chart, add to the base, the quantity of dye necessary to obtain the desired colour.
– Dilute the product with 5-10% of water.
– Mix carefully until the base is uniformly colored.
– Apply the colored plaster SETA with a short hair roller over the entire surface.
– After 10-15 minutes, smooth the surface with a SPATOLA
– Allow to dry to appreciate the effect (from 6 to 12 hours).
For more information see Technical Data Sheet